Technology

28

2018

-

07

Elimination of abnormal oil temperature

Classification:

Troubleshooting

【Summary】　　The magnetic field at the center of the end face of the housing when a high-gradient magnetic filter developed to handle high-viscosity gear oil is operated at different temperatures is tested. The results show that the magnetic field strength at 70℃ is only about 1/4 of 18℃. See that this test does not consider the holding time factor, but it is enough to prove that the magnetic field of the high gradient magnetic filter is significantly affected by the temperature

　　The magnetic field at the center of the end face of the housing when a high-gradient magnetic filter developed to handle high-viscosity gear oil is operated at different temperatures is tested. The results show that the magnetic field strength at 70℃ is only about 1/4 of 18℃. See that this test does not consider the holding time factor, but it is enough to prove that the magnetic field of the high gradient magnetic filter is significantly affected by the temperature

Previous Page

None

Next Page

None

Previous Page

None

Next Page

None

More support

Elimination of abnormal oil temperature

　　The magnetic field at the center of the end face of the housing when a high-gradient magnetic filter developed to handle high-viscosity gear oil is operated at different temperatures is tested. The results show that the magnetic field strength at 70℃ is only about 1/4 of 18℃. See that this test does not consider the holding time factor, but it is enough to prove that the magnetic field of the high gradient magnetic filter is significantly affected by the temperature

MORE

Significance and method of hydraulic system flushing

From the perspective of use, the first condition for the normal operation of the hydraulic system is that the inside of the system must be clean. Before the operation of new equipment, or after a piece of equipment has undergone major repairs, contamination of the hydraulic system is inevitable. It is possible to bring contaminants into the system during the installation of hoses, pipes and fittings. Even new oils will contain some unexpected contaminants.

MORE

Research on the integrated technology of "efficient cooling and Purification" of hydraulic system

For hydraulic and lubrication systems, oil overheating and contamination is an important cause of mechanical equipment failure. The fault of hydraulic system caused by pollution has been gradually recognized, but the harm of excessive oil temperature has not been paid enough attention. The total efficiency of the hydraulic system is usually only 50%~70%, so "high fever" is one of the common problems of the hydraulic system.

MORE